VisionStat Plus MA-BCKS-7.0 Uživatelský manuál stáhnout pdf (Strana 11)

VisionStat 5.6” and 7.0” Wired Video Monitoring Systems

Installation: Side Cameras (Continued)

If the viewing angle needs to be

adjusted, loosen the Camera Body

Nut and rotate the Camera Angle

Adjustment Rings until the proper

viewing position is achieved. Once

properly positioned, hand tighten

the Camera body nut securely.

Carefully place the side Camera

cover over the side Camera frame

so that the front lip of the cover

slides under the Camera lens, while

the back portion of the cover slides

under the Camera cover mounting

slot. Once the cover is properly

seated on the frame, where the co-

vers edges fit within the lip of the

rubber insulating pad, replace and secure the (2 each) frame release screws that hold

the cover onto the side Camera frame.

Carefully place the VisionStat logo clip on the lower front area of the side Camera as-

sembly by snapping the two (2) prongs into the open slots to the right and left of the

frame release screws.

Fig 15: Side Camera Mounting Bracket

Menus

The Wired Monitors menu will consist of three screens:

1) Picture

2) Option

3) System

1) Picture: The Picture menu will give you the option of

adjusting Brightness, Contrast, Color and Volume.

Press the CH– button on the Monitor to scroll up and

down to select your desired function. Press the ▲☼/▼☼

buttons on the Monitor in order to adjust the level of each

setting.

2) Option: The Option menu will give you the option of selecting Language, turning the

backing scale on or off and turning any of the (up to 4) Cameras on or off.

Press the CH– button on the Monitor to scroll up and

down to select your desired function. Press the ▲☼/▼☼

buttons on the Monitor in order to adjust the level of each

setting.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Žádné komentáře

VisionStat Plus MA-BCKS-7.0 Uživatelský manuál Strana 11