VisionStat Plus MA-BCKS-7.0 Uživatelský manuál stáhnout pdf (Strana 7)

VisionStat 5.6” and 7.0” Wired Video Monitoring Systems

Installation: Monitor and Wiring Harness

The standard Camera issued with the system is the 18IR

Camera which has a 120 degree viewing angle and is

rated IP68. This Camera comes equipped with 18 infrared

LEDs to provide night vision up to 12 meters. It is

mounted on a “U-Bracket” which allows the user to angle

the Camera up or down.

The Side Camera is typically featured in triple Camera

systems. This Camera comes equipped with 9 infrared

LEDs to provide night vision up to 8 meters. The

mounting bracket and protective cover is included with the

Camera.

For other Camera options and information, please visit

www.mobileawareness.com.

About the Cameras

Fig 3: 18IR Camera

Fig 4: Side Camera

Before installing the system, it is recommended to temporarily

connect all components and perform a system

function check. If the system does not operate

properly, see the troubleshooting section of this

manual. If further questions arise, please visit

www.mobileawareness.com or contact Mobile

Awareness directly.

The Monitor can be flush mounted in the dash

(with the included mount), with the “U-Bracket” and

thumb screws (see figure 4) or via the Dash Mount

Bracket (see figure 5). Make sure the mounting

location does not obscure the drivers viewing area.

Note: For other mounting options, please visit

www.mobileawareness.com

Fig 5: U Bracket and Thumb Screws

The VisionStat system includes a 22-pin wiring harness. This wiring harness will power

the entire system, including the Monitor and up to 4 Cameras. Once the Monitor is

mounted, align the Monitor’s 22-pin

connection with the 22-pin connection of

the wiring harness. Each connector will

have an arrow to assist with the

alignment.

Once engaged, slowly rotate the metal ring to thread the two connectors together. This

should be done with caution so that the connectors seat and thread together properly.

You may need to continue pressing the connectors together while rotating the metal

ring to facilitate the assembly. Following these steps will ensure the connection has

been made correctly. Failing to do so may cause problems with power, audio and

video connections. Twisting the cable, or the connectors themselves, to tighten the

connection may result in breakage of the pins and their connections, rendering the

wiring harness defective.

Fig 6: Dash Mount Bracket

Fig 7: 22-pin Wiring Harness

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Komentáře k této Příručce

Žádné komentáře

VisionStat Plus MA-BCKS-7.0 Uživatelský manuál Strana 7

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu VisionStat Plus MA-BCKS-7.0