VisionStat Plus MA-BCKS-7.0 Uživatelský manuál stáhnout pdf (Strana 14)

Mobile Awareness

Installation: Side Cameras (Continued)

If the viewing angle needs to be

adjusted, loosen the Camera Body

Nut and rotate the Camera Angle

Adjustment Rings until the proper

viewing position is achieved. Once

properly positioned, hand tighten

the Camera body nut securely.

Carefully place the Side Camera

Cover over the Side Camera Frame

so that the front lip of the cover

slides under the Camera lens, while

the back portion of the cover slides

under the Camera cover mounting

slot. Once the cover is properly

seated on the frame, where the co-

vers edges fit within the lip of the

rubber insulating pad, replace and

secure the (2 each) frame release screws that hold the cover onto the side Camera

frame.

Carefully place the VisionStat logo clip on the lower front area of the side Camera as-

sembly by snapping the two (2) prongs into the open slots to the right and left of the

frame release screws.

Fig 22: Side Camera Mounting Bracket

Fig 21: Side Camera Mounting Bracket

Installation: Side Cameras (Continued)

Connect the included extension cable

(s) prior to mounting the Camera to

the Side Camera Frame. This will

allow you to thread the metal

connectors together, tighten them

securely and then slide the rubber

boot completely over the mated

connectors. This will assure a

watertight and trouble free connection.

When connecting to the Wiring

Harness, the left side Camera should

be connected to the WHITE Channel

One 4-pin Connector and the right

side Camera to the BLUE Channel

Two 4-pin Connector, via the included

extension cables.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Žádné komentáře

VisionStat Plus MA-BCKS-7.0 Uživatelský manuál Strana 14