VisionStat Plus MA-BCKS-7.0 Uživatelský manuál Strana 21

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 28
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 20
21
VisionStat Plus Video Monitoring and Obstacle Detection Sensor System
System Operation
A) Automatic Self-Test: Whenever the system is enabled, it will perform a self-
test. Any Sensors that are blocked or inoperable will display an error message de-
noted by E1, E2, E3 or E4 (Sensors numbered left to right facing the back of the
vehicle). After the self-test, the system will automatically remove the icon display of
any inoperable Sensor(s) and begin operating (even when a Sensor is malfunction-
ing). For example, if E4 were malfunctioning, the remaining three Sensors would be
displayed.
B) Inoperable Sensor: If any of the Sensor icons are not displayed, attend to the
repair of that Sensor immediately. In the case of an inoperable Sensor, do not back
up without walking around the vehicle first and proceed with extreme caution.
C) Blocked Sensor: Carefully remove any snow, ice or dirt that may have built up
on an inoperable Sensor. When placed in reverse the system will retest the Sensors
indicating if the problem still exists.
D) Minimum Detection Distance: The minimum detection and display distance is
8.7 inches (22cm); a person (or an object) can be detected most reliably within 67
inches (1.7M) behind the vehicle or less.
E) Relative Accuracy: The display indicates the distance with 1.0 inch accuracy.
For example, if there is an object within range of the left side rear of the vehicle, the
S1 icon will indicate by flashing and displaying the distance in feet and inches. If the
object is moving to the right, the display will adjust in real time to indicate this move-
ment.
F) Detection Range: The middle Sensors (S2 & S3) start audible warning from 67
inches (1.7M); the corner Sensors (S1 & S4) start audible alarm at 39 inches (1.0M).
CAUTION: The system will never alert you to any obstacles behind a
malfunctioning Sensor; the icon for that Sensor will not be displayed on
the Monitor.
Sensor Visual and Audible Warnings
NOTE: The audible alarm from the Monitor is 800 Hz and around 60-70dB when
1-3 feet away from the Monitor. The LED Bar is not available on VisionStat Plus,
only SenseStat.
Zobrazit stránku 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Komentáře k této Příručce

Žádné komentáře